How the job runs
- 1Measure the rough-inconfirm the distance from wall to flange bolts so the new toilet fits
- 2Remove the olddrain, disconnect and lift out the old toilet, plugging the drain against sewer gas
- 3Inspect the flangerepair or replace a broken or corroded closet flange
- 4Set the new bowllevel it on a new wax or foam seal and tighten evenly
- 5Connect and testfit a new stop valve if needed and a braided supply, then flush test
01Fit matters
Before you buy a toilet, measure from the wall behind it to the bolts on the floor. Most are twelve inches, but some older Scarborough bathrooms have ten or fourteen. Buying the wrong size means the tank either hits the wall or sits awkwardly far from it.
If you are unsure, phone and we will walk you through the measurement.
| Standard rough-in | Usually 12 inches from finished wall, but older homes vary |
|---|---|
| Low-flow | Modern toilets use far less water than the 13 to 20 litre models of the past |
| Old toilet | We take it away |
02The flange
In houses with cast-iron drains the closet flange is often lead-caulked or brass, and decades of moisture can leave it cracked or rusted. We repair it with a spanner flange or replace it, so the new toilet is anchored solidly.
03Comfort height and one-piece models
Taller bowls are easier on knees and hips, and one-piece toilets are easier to clean. We install whichever you choose and explain any trade-offs in water use or price.
04Supply valves
A new stop valve is cheap insurance.